Carrier — Furnaces & Space Heating
Carrier Furnaces Repair & Installation in NYC
Gas furnaces, direct-vent and vent-free wall furnaces, and electric baseboard/wall heaters for residential and light-commercial heating.
Installation
We install new Carrier furnaces equipment, not just repair existing units. New furnace and space-heater installs are sized to the space and existing ductwork or venting, with old equipment removed and the new unit commissioned before we leave.
Carrier Furnaces Repair
Gas Furnace
Common symptoms: Furnace won't ignite, short-cycles, blows cold air, or the control board's status light is flashing a fault pattern.
Likely causes: Ignitor failure, flame sensor fouling, pressure switch fault, blocked condensate line, or a limit switch tripped by restricted airflow.
What we check first: Ignition sequence, flame sensor signal, pressure switch operation, condensate drainage, and any stored fault history on the board.
What work is done: Ignitor or flame sensor replacement, pressure switch or hose repair, condensate line clearing, and airflow correction where restricted ductwork is the root cause.
When to call: As soon as the furnace won't hold a call for heat, cycles more than a few times an hour, or is blowing air that isn't warming up.
Frequently Asked Questions
Does AM Profs Inc install new Carrier furnaces, or only repair them?
Both. New furnace and space-heater installs are sized to the space and existing ductwork or venting, with old equipment removed and the new unit commissioned before we leave. We also diagnose and repair existing Carrier furnaces equipment.